Jan 7, 8.
Sep 11, Removal Tool for pulling / pushing out axle pivot bushings on a TTB front bushdig.bared Rodnylon nut or weld one on socket the size of the bushingreceiver fro. Lower the axle. 3 Removal Preparing the pivot bushing removal tool The pivot bushing removal tool (hereafter abbreviated to removal tool) consists of a hex-head threaded rod (1), two thrust washers (2), a thrust bearing (3), two more thrust washers (2), a cover plate (4), a receiver tube (5), and a drive nut (9), as illustrated in Figure 1.
Aug 08, Here I remove the cup of the original axle pivot bushing w the oxyMagneGas2 torch. I removed the inner sleeve with a puller made w sockets and a washer nut &. Removal. Remove axle. Refer to Dana Four-Wheel Drive Front Drive Axle Removal and Installation in this section.
Install Suspension Bushing Service Set T78PA1, Bushing Remover T80TA1 and Receiver Cup T78PA3 onto the pivot bushing. Turn the forcing screw and remove the pivot bushing. Installation. Place pivot bushing in axle bushdig.barted Reading Time: 3 mins. Step Push the axle pivot bushing carefully until it is forced into the receiver tube's widened section. Step To disassemble the removing tool, just simply reverse the wrench. Step Use a wire brush to clean all the foreign materials and the old axle pivot bushing left in the receptacle.
This process can take an hour or two. Sep 16, BX front axle bushing removal tool. My Kubota BX has developed a leak in the front axle pivot bushing. Dealerships charge anywhere from to bucks to pull your front axle and replace the bushings. NOTE: Torque the pivot bolts with the suspension at ride height to prevent pre-stressing the rubber pivot bushing. Torque the adjuster plate nuts to 55 - 60 ft-lbs. 4. Align the aft axle(s) to the forward axle to within ± 1/16” using the same procedure (Figure 4).
5. In general, small alignment changes can be made on one side (left hanger or. remove the pivot bolts and outer alignment collars from both sides.
Figure 2 6. Lower the trailing arm and axle assembly down and out of the hangers. Discard the locknuts, pivot bolts, wear washers and alignment collars.
7. Apply a small amount of lubricant around the radius of the bushing with the bushing still in the tube. Meritor recommends. Mar 02, If its supported with jack stands behind the leafsprings and tires off take the pivot bolt out (support the axle. with floor jack) chesterfield tree cutting services axle bushdig.bar inner axle shaft may be whats holding you bushdig.bar even have to disassemble pass side hub to remove axle shaft to allow axle housing to.
come down far enough to press the bushing out.