Leverage pins with multiple access points allow user to change the angle.

Tool Number: J Tool Name: Bushing and Bearing Remover - ( inch) Applications: Camaro with Aisin or Tremec Transmission The rear seal on manual transmissions is installed deep into its bore in the extension housing. List:(0) LIP SEAL PULLER. LSP1A. Works better than all other pullers available on the market for import car lip seals for front cam and crank seals.

Slim, ergonomic design fits into tight areas and has no moving part to adjust, making seal removal a snap. TOOL, GM SHIFT LEVER SEAL REMOVER/INSTALLER Install over shaft, Tap with hammer, Turn Tool with wrench to capture seal. Screw in bolt to extract seal.

Slim, ergonomic design fits into tight areas and has no moving part to adjust, making seal removal a snap.

Install new seal. Jun 14, The seal im going to replace and should be no problem but i am taking about the bushing that sits behind the seal. That one either i take off the rear part of the transmission and take it to a machine shop so they can replace the bushing, or i read that with one of those special tools you can remove the bushing and insert a new one without removing part of the bushdig.barted Reading Time: 11 mins.

Bushing and Seal Remover Use this tool to remove the output shaft bushing from 42RE and 46RE automatic transmissions and the output shaft bearing from transfer cases. Also used on NV, NV, NVGENII, NV,NV and NV Transfer Cases. Also used on NV, NV & NV Manual bushdig.bar: SPX/Bosch (OTC Rotunda Kent-Moore Miller).

1. Remove the 6 screws that hold the lower gear housing together. 2. Remove propeller shaft and gears. 3.

This item may not be in stock; please email service toolsource.

Remove the driveshaft and the shift rod. 4. Use the bushing removal to tap out the old bushing. 5. Remove the old o-ring 6. Put in a new o-ring. 7. Place a new bushing on an installation tool and tap to install flush with the housing.

8. Reassemble5/5(37).