When you have the key out of the

Aug 04, Tailgate cable on the body side has clips on it. Pull clip up side off bolt (watch the paint). Likewise on the other side (hold TAILGATE it will fall into bumper and cause cussing fits).

Tilt tailgate upward half way. Pull up on passengers side. Step Back one step pull off slowly from drivers side (AGAIN watch the paint). disconnect tailgate stop cables; open tailgate normally but stop when you are nearly halfway down (45 degree angle to ground). now, pull heartwood tree removal away from bottom pivot (hinge) pin on either the left or right side of tailgate.

This should allow both hinge pins to be free from the rest of truck. Aug 02, Re: Need replacement tailgate hinge pivot bushing.

Loosen the strikers with a Torx bit to change their positions; make small adjustments at a time.

Aug 15am. Number 24 in the attached pic is the rubber bumper that mounts on the latch. GM part number bushdig.bar You do not have the required permissions to view the files attached to this post. Mar 12, Chevy Silverado/GMC Sierra tailgate hinges, cables, and striker replacement. Step by step instructions on how to replace your worn out tailgate com. Apr 23, I had been having nothing but issues with the easy open tailgate bushing breaking. It has been replaced 4 times now by my local dealer and all have been unde.

Jul 03, This Tailgate is so easy Chevrolet calls it EZ. But here's a how to video for all you soon to be New Silverado Owners! The New Silverado is"Strong". Aug 04, Tailgate cable on the body side has clips on it.

Pull clip up side off bolt (watch the paint). Likewise on the other side (hold TAILGATE it will fall into bumper and cause cussing fits). Tilt tailgate upward half way. Pull up on passengers side. Step Back one step pull off slowly from drivers side (AGAIN watch the paint). disconnect tailgate stop cables; open tailgate normally but stop when you are nearly halfway down (45 degree angle to ground).

now, pull tailgate remove tailgate bushings 2010 silverado from bottom pivot (hinge) pin on either the left or right side of tailgate. This should allow both hinge pins to be free from the rest of truck.

Oct 22, Silverado Rack and pinion 'Bushings" Oct 22pm. I have a Silverado with a RC lift. I do not have any alignment problems while driving. I was told today by a local shop that my power steering rack has to much play so I would need to change the Rack and Pinion because you can't just change just the bushings.

Aug 19, That year of truck doesn't use the bushing. If I'm correct, the hinge is built so the the tail gate goes over the pin in the bed side. The slot on the tail gate is there so you can remove the tailgate. bush 17l cross cut shredder